Mini Split Installation in Clovis, NM
A new system here will heat from October through April and cool from June through September every year. Tell us about the house, and a licensed contractor who covers Curry County will get in touch.
Tell us about the job
It takes about a minute.
What Clovis winters and summers ask of a mini-split
Your mini-split works eleven months out of the year here. It heats the house from October through April, on nights that average 25°F, then switches over to cool it from June through September, on afternoons near 90°F. That is a long duty cycle for one piece of equipment, and it means the unit needs to hold up on both ends, not just one.
A new ductless heat pump has to meet 14.3 SEER2 for cooling and 7.5 HSPF2 for heating if it was built in 2023 or later. That is the federal floor, and any mini-split installed today should clear it.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 25°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
New Mexico requires HVAC contractors to hold a state license.
The Construction Industries Division issues this license, and it covers the contractor rather than any single job. The same license that lets someone install a mini-split in one home covers the next one too.
For this job, that license is what stands behind the refrigerant work and the wiring that makes the system run. In most cities and counties, the installation will also need a permit from the local building office and an inspection once the work is done, separate from the contractor's license.
Source: New Mexico Regulation and Licensing Department
- Is a mini split worth it?
- For most homes here, yes. Clovis needs heat from October through April and cooling from June through September, so a system that does both jobs well earns its keep most of the year. A mini split heats and cools without ducts, and it can be sized for just the rooms that need it, like a converted garage or an addition the main system does not reach well. A contractor can look at your house and tell you whether one zone covers your need or whether you would want more.
- How many rooms can a mini split cover?
- A single outdoor unit can run anywhere from one indoor head to about eight, depending on the system. Each indoor head is sized for the room or area it serves, so a multi-zone setup can cover several rooms off one outdoor unit while a single-zone system is built for one space. The right count comes down to the size of the rooms and how the house is laid out, which is something a contractor works out room by room.
- Can a mini split heat a whole house?
- It can, if it is sized and placed for the whole house rather than a room or two. That matters here since winter nights average 25°F through December, January and February, so the system has to be able to keep up on the coldest nights, not just take the edge off. A whole-house layout usually means multiple indoor heads feeding the rooms that need them, and a contractor can work out how many zones your house needs to be covered end to end.